...
In my opinion there wouldn't be much of a difference between these two options, but I'm on the side of just following what the datasheet says to do since there may be some weird current flow stuff if we just connect the nodes externally. Plus it wouldn't be too difficult to solder a trace on if this is actually the issue.
Issue 3.1: Last Value in Minion is Invalid
PROBLEM CHILDREN 3: 3/21/24
Voltages = {
35629, 35625, 35612, 35620, 35617, 35617, 35621, 35618, 35608, 36027, 914,
35600, 35597, 35594, 35606, 35599, 35606, 35612, 35609, 35594, 31586,
35617, 35624, 35615, 35627, 35623, 35627, 35622, 35635, 35611, 35629, 13320}
$3 = {
35630, 35624, 35615, 35621, 35617, 35615, 35624, 35619, 35610, 35991, 956,
35602, 35594, 35594, 35602, 35591, 35603, 35608, 35612, 35594, 31582,
35616, 35627, 35616, 35627, 35623, 35627, 35620, 35633, 35610, 35630, 13345}
$4 = {
35631, 35625, 35614, 35620, 35618, 35618, 35624, 35620, 35610, 35953, 1042,
35599, 35597, 35596, 35604, 35598, 35607, 35611, 35607, 35591, 31584,
35616, 35624, 35615, 35628, 35624, 35627, 35620, 35634, 35611, 35629, 13324}
These are 3 readings of the Voltage array after running it.
The last module in each minion is wrong.
The voltages of the 11th Module in the segment change much more than the other modules per run