Page Comparison

1. This process is exactly the same for both Surround and Stereo Mixes.
2. Open your session following the instructions in: Opening Your Protools LE_Session in PT_RM5.
3. In the Protools tool bar click: File>Import>Session Data…

  4. In the “Templates” Folder, Select “Effects Template” and Click Open.

Image Added

5. Select the Tracks that Correspond to your mix; 5.1 Reverb for a surround mix,Stereo Reverb for a stereo mix. Import the Boom Channel only to add Subwoofer
to a SURROUND MIX. Subwoofer should not be used for a stereo mix.
When you have selected the appropriate tracks. Click OK.

Image Added

6. Click on the Sends arrow (the up down arrows at the top on the Light grey part of
the mixer, and select bus, then the reverb send or boom send that you wish to use on
that track. If you want to have the option to use reverb on every track, hold down
option before you click.

Image Added

7. Make sure that you do not assign the Reverb Send/Boom Send to the Reverb or
Boom tracks. When you have finished these steps your session might look like this:

Image Added

8. To automate your reverbs (so that you can add more or less reverb to a track) Click
into the Edit Window and click on the track that you wish to add reverb to.

Image Added

9. Click the button that says “Waveform” and Select the reverb/Boom that you want
to mix in>level.

Image Added

10. Using the Grabber tool:  !Screen shot 2010-11-15 at 9.41.39 AM.png

border=1!Draw in the amount of reverb that you want to send:

Image Added