This document explains the process to live stream from the JVC GY-HM660U remote camcorder through a personal user's hotspot to the control room.
Will you be on campus or off campus?
ON CAMPUS - The following instructions are for on campus use. This uses the utexas-iot wifi.
BEFORE YOUR SHOOT CHARGE THE BATTERIES PLUG IN THE CAMERA WITH THE BATTERIES IN THE Camera and let it charge till all the batteries are charged The orange light will be blinking on the camera while the batteries are charging. 4 blinks = less than 25% charged 3 blinks = less than 50% charged 2 blinks =less than 75% charged 1 blink = less than 100% charged | |
Setup the remote camera like you normally would. Probably with a tripod. | |
Plug your lav or handheld into Input 1. If you do not, the control room will not have audio from you. | |
Make sure your input settings are correct. Channel 1 should be set to Input 1. | |
Power On the camcorder by pushing in the blue release button and sliding the switch to the ON position | |
This symbol will flash and then turn solid yellow. It will turn from solid yellow to solid white. When it looks like this it is ready to stream to the control room. | |
Press the OIS/2 button. This will start streaming video back to the control room. | |
You should see a little red "LIVE" icon in the top of the camera view finder screen | |
Not working? Try loading the On Campus configuration by: 1. pressing the menu button 2. Choose System... 3. Choose Network Settings... 4. Choose Connection Setup... 5. Choose Load 6. Choose CAM1 ONCAMPS 7. Set 8. Load |
OFF CAMPUS - The following instructions are for off campus use. This uses the student's cell phone data via their hot spot.
Setup your camera DON'T FORGET TO CHECK OUT A TRIPOD WITH THE CAMERA PACKAGE!!
...