Turn on The deck you want to use in the dub rack |
|
Go to the little video patch panel in back of the rolling rack filled with the tape decks. Patch the deck you want to use into the TBC input. In our example we are capturing from VHS so we have the VHS deck patched into the TBC Input If you wanted to capture from Hi-8 or Beta just move the BNC from the VHS to the Hi-8 or Beta or 3/4 Out. |
|
Patch out of the TBC and into the Teranex |
|
Patch out of the TBC and into the Teranex Y/NTSC/PAL IN |
|
You are also going to have to move the audio XLR Left and Right to the correct output for the deck you want to use |
|
This will be patched into the small audio board on the desk and this will send audio into the Teranex |  |
Make sure the Thunderbolt cable is connected to the computer (IMac) and the Teranex |
|
Put the tape in the deck |
|
Click on PLAY make sure there is some image on the tape and play for a at least 20 seconds |
|
Turn on the Teranex - wait till it boots up - if on turn off then on again |
|
System Prefs >Blackmagic Design Desktop Video |
|
| Change Input to Compostie Video and Analog XLR Audio Set Default video standard as HD 1080p 23.98 |
|
Open Blackmagic Media Express |
|
Go to >Media Express> |
|
Set the Video Format to |
|
Click on the Log and Capture Tab in Media Express |
|
...
Set Input or "IN" Video – Analog or ANLG Audio – Analog or ANLG Format – 486 Frame – I Rate 59.94 Aspect Leterbox ADJ – can adjust levels and some other things |
|
NEXT - SELECT ANLG ON THE VIDEO |
...
TAB |
|
| Make sure it is set to Analog Input > Composite |
|
| NEXT - SELECT ANALOG on the Audio tab |
|
Analog > XLR > Analog Input |
|
|
...
Video – SDI Audio – EMBED - Analog Format – 1080 Frame – P Rate 23.98 Aspect Leterbox ADJ – can adjust levels and some other things |
...
|
You should see audio levels Then click on the Capture Button to start capturing. Capture Button will turn RED |
...
| |
| Click Capture to stop capturing |
|
| Turn off the Teranex when finished |
|
| TURN OFF THE VTR'S WHEN FINISHED |
|
