Versions Compared

Version Old Version 5 New Version 6
Changes made by

Susanne Kraft

Susanne Kraft

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Open Focusrite Control if you haven't already

Click on Output Routing

Make sure that the FocusRite is synced to Internal

Click on Device Settings

Red 4Pre

Clock Source make sure it is internal

Image Added

Click on >File Load Snapshot

Go to >Tempstorage>

Templates>Focusrite surround sound setup.ff


Click Open

Note in case it's lost here are the settings for

outputs 3-8

Open audio midi setup and choose setup 

Image Added

Choose >Focusrite Thunderbolt

Image Added

Configure Speakers



Image ModifiedImage Removed

Choose Configuration 5.1 Surround


>Focusrite Thunderbolt and 5.1 surround config


Each speaker output should send a signal to this cable 

Choose Apply and >Done

Next open protools ultimate to get 8 channels output
Set playback engine to 

Set to Focusrite Thunderbolt

Then Import the surround sound template for the input and the output

Choose 


Import Settings

Choose >tempstorage>Templates> UT RTF Default .pio

Choose NO here

Click OK



...