...
| Click on Computer to Start the system |
|
| Then click on Advanced |
|
| Then click on Surround Sound |
|
For ProTools audio output choose Mix Station Discreet Audio Output (PROTOOLS) Projector input choose HDMI Mix Station Program |
|
VERY IMPORTANT when you are recording you need to MUTEthe Crestron System or you will get BAD FEEDBACK
|
|
Locate the snake under the platform in front of the Mix Desk Plug your mic into one of the first 4 inputs of the mic snake. |
|
| Log into the mix station computer |
|
Open the application called  called Focusrite Control |
|
Then > Click on >File Load Snapshot |
|
Navigate to the Focusrite CMB4.122 Studio C ADR.ff Go to >tempstorage>templates> Focusrite CMB4.122 Studio C ADR.ff |
|
Now go back to ProTools Application setup Open the ADR Template in the "Templates" folder on the "tempstorage" Drive Open UT_ADR_Template.ptx |
|
Open the ADR Template in the "Templates" folder on the "tempstorage" Drive Open UT_ADR_Template.ptx |
|
This Message prompt will tell you that your audio is getting routed differently it is OK to click on NO you don't want a detailed report |  |
When the session opens> Go to >File>Save As |  |
| Choose a place to save your session on your Hard Drive and click OK |  |
SET THE INPUT ON THE TRACKS On the Track Labeled "ADR_001" Make sure that the input matches the mic input that you plugged your mic into on the "Snake." Click on A1 and change it to A1, A2 or A3 or A4 depending where you plugged in on the "Snake" |  |
SET THE OUTPUT ON THE TRACKS Click on "Main" and set the output to Main (5.1>A 1-2 Stereo)
|  |
| |
| Plug Headphones into the headphone splitter. This device is located under the desk to the right in the rack |
|
The headphone jacks 1-4 control the volume for the "Talents" headphones that are plugged into the snake
|
|
Plug your headphones into the headphone amp 5-8 under the rack under the console and adjust the "Input Level" so you can hear audio in your headphones comfortably once you start testing levels coming into ProTools later in this doc. |
|
VERY IMPORTANT when you are recording you need to MUTEthe Crestron System or you will get BAD FEEDBACK
|
|
...