...
Locations of both kits are: DMC 3.208 on the shelf as shown here | |
One Kit is in the The CMB 4.130 control room | |
This workflow assumes we are beginning with the equipment off, dark, and stowed. | |
Gently pull the camera unit out of wall recess with the handle provided. | |
There are 6 objects to turn on, and they each turn on in different ways. They must all be turned-on for this equipment to function properly. | |
1) Turn on the light-switch labeled "Local Reporter Flat-Panel Lights" on the opposite wall. | |
2) Turn on the wall mounted Program Out monitor by pressing the button on the bottom right-hand side. | |
3) Turn on the top, shelf-mounted Teleprompter monitor by pressing the button on the right side. This button is a little difficult to find. | |
4) Turn on the lower, Local Reporter monitor by touching the power symbol on the bottom right side. | Remove the cloth cover from the camera. Place the cover next to the camera, so we can put it back later. |
Turn on the PTZ Camera locate the remote that is attached via velcro to the camera tray | |
Press "CAM01" then press and HOLD the red button for at least 2 seconds to turn thecamera on and display a GREEN light!! | |
Ensure the Telex Telecaster is on. It is most likely already on. Look for green lights like so: If it is not lit up, the power switch is on the far right of the unit. Switch it to on. | |
At this point, the equipment should all be turned on, and look something like this: | |
Control Room should see the DMC 3.208 Image on input CAM 4 on the Ross Switcher |
Next, we're going to set up the Live Reporter kit
To set up a Wired Lav microphone, you will need:
| |
Remove the lavalier mic from the case, and unscrew the metal body to open it up. | |
Place the AA battery inside the mic, and screw it back together. | |
Plug the XLR cable into the microphone. | |
Place the mic clip on the microphone if it is not already on the mic. | |
Clip the mic to your subject's chest at approximately the center of their sternum. | |
Plug the opposite end of the XLR into the Mic plate labeled Mic 1 | |
The audio will be coming out of Input 6 on the Wheatstone | |
Audio board make sure that the channels are off and the faders down when you change A to B and vice versa Make sure you select input A MIC N1 |
...
Remove and break-down the lavalier microphone and IFB. Make sure to remove the battery from the microphone. Place them both in the Live Reporter Kit. | |||
Turn off the camera by pushing the red power button on the remote. The power light on the camera will turn amber. | |||
Put the Remote Back on the Velcro on the tray | |||
Turn off the AJA KiPro Mini by holding down the power button for 3 seconds. The KiPro Mini will display that it is shutting down. | |||
Turn off the 3 monitors by pushing the power button on each of them. | Place the cloth cover back on the camera. | ||
Gently push the camera shelf back into the wall-rack. | |||
Now the monitors and KiPro in the rack should be dark and stowed. | |||
Turn off the Local Reporter Flat-Panel lights. | |||
Return the Live Reporter Kit to Equipment Checkout in CMA 3.104. |
...