...
We decided to 3D-print the holder because of the complicated shape. The hole seen at the bottom of the holder is where a shaft connects the holder to the end of the linkage. To test how well the holder worked, we vigorously shook the holder with the shaker inside to mimic the worst-case scenario.
name | shaker testing.MOV | width | 250 |  |
When attaching the shaker holder to the linkage our team found that we did not make a long enough base plate. To solve this problem we glued wood to the bottom of the shaker holder to make sure the bottom of the holder make contact with the bearings.
...