Tracing a complex continuous curve requires high repeatability. To achieve this, the design and manufacturing requirements called for low tolerance and high quality joints. The linkage joints used the provided bearings, shafts, and retaining clips as well as washers to minimize axial friction. This joint design was tested on two previous prototypes and proved satisfactory.
...
The ground plate was made of plasma cut steel sheet
Used water jet to cut complex cam curvature and links
Used plasma cutter for ground plate
use of numerically controlled processes allowed precise hole location, but poor hole quality
addressed this by undersizing and drilling to size
Press fit shafts and bearings into links for robust and smooth joints
Coupled motor to cam plate with shaft and bevel gears
Found proper springs to provide enough tension to keep followers in contact with the cam throughout the range of motion