Page Comparison

Step-by-step guide

How to Add the Plotters to ImagePro

1.  Open ImagePro by clicking the Windows icon in the bottom left corner of your screen and searching for "Kip"
   1. Image Added
2. Once the program loads, click on Settings in the top right-hand corner
3. On the left hand side of this page, click Settings. You should be looking at the following screen now
   1. Image Added
4. Click on the lock next to Application Mode which will unlock it
   1. Image Added
5. Uncheck Scanner Only. Make sure it is unchecked
   1. Image Added
6. A connection window will open up. Select Add Connection
7. The following window will appear
   
   1. Image Added
8. For name, type in "MARJAN"
9. For IP address, replace whatever is in that text box with 172.16.86.178
10. Leave the port set to the default 9888
11. The window should look like this
    
    1. Image Added
12. Click Save
13. Click the dropdown on the connection window. You should see MARJAN. You may have to wait a minute or so for the red light to turn green, as shown below. Once it is green, click on it.
    
    1. Image Added
14. A login window will appear. Type in your EID and password into these boxes and click Connect
    
    1. Image Added
15. Under Scanner Administration in the upper right section of the screen, select the dropdown under Active Scanner and select No Scanner.
16. You can now click Home in the top left of the screen to go to the main plot submission section. Follow the steps on the next sections of this page to submit a plot.
17. To add our second KIP plotter to your ImagePro, navigate to Information and Click Add Connection
    1. Image Added
18. A connection window will open up
    1. Image Added
19. For name, type in "DOUG"
20. For IP address, replace whatever is in that text box with 172.16.86.176
21. Leave the port set to the default 9888
22. The window should look like this
    
    1. Image Added
23. Click Save
24. Click the dropdown on the connection window. You should see DOUG. You may have to wait a minute or so for the red light to turn green, as shown below. Once it is green, click on it.
    
    1. Image Added
25. A login window will appear. Type in your EID and password into these boxes and click Connect
    
    1. Image Added

Related articles