Versions Compared
Key
- This line was added.
- This line was removed.
- Formatting was changed.
Excerpt |
---|
ProblemThe Shopbot CNC does not calibrate to 0,0 properly and throws an error related to the motor or limiter sensors. If you see this error it is because the ShopBot CNC hit a limiter sensor or proxy switch that caused a fault in the calibration and requires re-calibration. Image Added SolutionThe Shopbot CNC machines are designed with a limit sensor for each axis. One of the limiters is a physical stop to keep the gantry from walking off the rails; if you hit these you will have to re-initialize the Shopbot CNC machine. The other limiter is a light sensor to assist the machine with it's 'homing' function (C3). It is important to not enter commands that are beyond the limits of these machines. For example; both of our CNC machines have a 60" Y axis and a 96" X axis beds. pushing either of these numbers beyond their limit will incur a limiter switch error.
|
...