Elevate Single Surface
SZB 4th Floor Labs, SZB 518C, AHG Classrooms, etc.
Homing The Legs
Sometimes the table will be "stuck" and will only go down. Follow these steps to correct the issue:
- Press down button until the table reaches its lowest point and stops moving. Release the button for 1-2 seconds. Press down button again for 3-5 seconds and you will see the table home itself.
- Press up button until the table tops at the highest point and hold for 3-5 seconds. Press the down button for 2-3 seconds, then the up button again until it tops at the highest point and hold again for 3-5 seconds. (The goal is to have the table hold at it’s highest point twice.)
- If the legs ever fail to function properly, unplug the power cord, wait 10 seconds, plug the power cord back in and repeat the above steps.
- Legs must also be homed any time that power is disconnected from the legs.
- If the legs are not homed at both the top and the bottom, the table will only move at half its normal speed.