Page Comparison

General

Suspension

Steering

Unsprung

Quick review of one person from each subsystem on what they are doing/did

Members working on bump steer research throughout the week. Workday will continue to refine steering geometry. Start working on real steering cad (ie modelling physical linkages) and upper steering design. Work on implementing bump steer optimization. If Jacob is there ask him about bump steer and his code.

Last workday we worked on CAD, decided we are going to CAD then validate instead of working forwards.

This week

Sami, Sumi, and Sohan

• 2 Upright design each

• 2 Hub design each

  • should have 6 design to choose from

  • If u need dimensions ask me.

  • Use global variables and be creative, if its too complicated we will figure out to dumb it down later.

  • Using these we will validate each design and sim them hopefully on workday

  • From that we will choose bearings.

Jonathan

• Cad the rear swingarm, focusing on designs which show

  • methods of motor mounting

  • methods of caliper mounting

ClickUp

ClickUp

ClickUp

ClickUp

End of workday meeting

• Everyone goes through what they did first members then subleads

• Subleads tell their members what they will be doing throughout the week (technical things related to their task)

• General thing they will be doing throughout the week (CAD)