Setup the Tripod first
Spread the legs of the tripod to the width you think will be wide enough to support the tripod |  |
Adjust the length of the legs so they are even and the desired height you want the camera |  |
The knob underneath the tripod head will allow adjustment of the head so you can level it using the yellow Bubble on the tripod head |  |
| Bubble on the tripod head used to level the tripod |  |
Turning the knob on the side of the tripod will allow you to adjust the handle on the tripod. |  |
| Screw in the tripod plate in the "third" smaller hold and tighten |  |
Pull Latch shown here to unlock the plate and push it in to lock the plate on to the tripod
|  |
Pull Latch shown here to unlock the plate and push it in to lock the plate on to the tripod |  |
| To adjust the Pan Lock use the knob in the front of the head |  |
| This knob will adjust the tilt of the head |  |
Turn this knob to loosen the pan handle to adjust the position. Lock it in place when at the right position. You will have to put it back down flat when packing it up in the case. |  |
Page Comparison
General
Content
Integrations