...
After multiple prototypes, our team discussed how to create the angle change in the shaking motion. Initially, we thought of laying the linkage flat and adding something underneath to lift the entire plate up and down. Ultimately we decided to turn the linkage so that the shaker would sit horizontally above the ground and add a cam below the plate to help change the angle of the linear motion. We created a stand that would allow the linkage plate to stand upright and allow for space to hold the cam underneath the plate. We also designed a simple shaker holder that features a shelf to keep the shaker level.
Initial Design
Below is a Peaucellier-Lipkin linkage which can transform rotational motion into a perfectly linear motion and the CAD model with final dimensions.
| 2D Motion-Gen Model | CAD Model |
|
|
Rough Prototype
...
The path of motion of the output joint was a straight line, which is what we wanted, meaning we could move on to the next iteration.
|
|
|
Physical Prototype
Our final prototype we made out of laser-cut wood, screws, and nuts. We scaled it down to save resources. This prototype allows for a full rotation of the crank and follows a straight path at the output joint.
There was some slight sticking in this prototype and this was due to screw heads and nuts needing a lot of extra space. The final system will be smoother because we will use axles and bearings.
|
name | proptype2.mp4 | width | 200 |
|
Linkage Plate Design
We designed the plate to have bearing connection points to help decrease the friction between the shaker holder and the linkage plate. This will make the linear motion of the shaker run smoother.
...
| Initial Design | Second Design |
 |
|
Second Design
Our second iteration of the mechanism has a crank or cam mechanism to rotate the entire linkage plate. A pivot point is needed on the edge of the linkage plate to rotate about. This is how we incorporated an angle change.
...
| Initial Cam (Diameter = 14 cm) | Second Iteration of Cam (Diameter = 1.25 in) |
|
|
