Objective
Research how a double wishbone suspension does it’s thing and how it can attach to frame
How would susp hardpoints change if we’re looking into external susp instead of internal?
How do we make the front of chassis around those hardpoints?
...
Figure out how a double wishbone suspension works
Find out what makes up a suspension
bell crank tab, shock mounting tab, toe-rod, etc.
Look into “multilevel” frame arc - see notes over suspension conversation from today.
Design considerations for frame to accommodate front suspension geometry
Look at the old susp design, and what we could change about that so the new sys is the best it could be.
What loads are gonna be at these hardpoints, and how do we create geometry (cross brace) to counteract?
By the end of 10/19/2024, have the following done:
Project goals
Background research
Notes from discussion with suspension
Any design criteria and other considerations
Any sources used
Any visuals used
Double Wishbone Suspension - How does it work?
To first understand DWS, it’s important to understand camber.
...
These are cool because they allow each suspension to act independently - if there is a bump on the road that affected only the front right wheel, it’s suspension system is the only one that would react. (Race Car Design by Derek Seward - 3.1: Introduction to Racing Car Suspensions)
The Bell Crank
...
Push Rod, Bell Crank, Shock
A push rod “pushes” so that the bell crank can transfer motion to the shock. (pull rods also exist)
A bell crank pretty much acts as a motion-transferring intermediary b/w shock and push rod.
Shocks make sure spring don’t compress/extend excessively, also springs do suspension essential func.
Multilevel Frame Architecture
...
Important note: External vs Internal suspension system hardpoints are the EXACT same.
10/26/2024 Meeting W/Suspension
...
Transcription so you can read:
Objectives:
Understand Bell Cranks
Hex vs Rect multilevel frame arc
Improve current front frame design
You don’t want a large mounting distance, one problem w/this is huge upright.
One problem w/Daybreak - pedal box
Ergo unhappy (small space)
Suspension unhappy (ctrl arms far apart)
Frame unhappy (prob bad load handling)
Overall, loss-loss-loss situation
Hexagon frame is better cuz smaller top control arm (facilitates negative camber for cornering)
Note: Recommendation for dY b/w ctrl arms is 9 in, sus currently tryna do 8 in.
Below are diagrams, ignore everything except for the bottom left hexagon. It’s a diagram of how suspension would look like on the front frame.
Taking a look at the Old Suspension and Frame Systems
Observations (suspension)
...
Should we use a diagonal pipe at the front? I notice some FSAE teams use that. What’re the pros and cons of each?
...
There is a TON of pipes.
Why are “X” shaped crosses used in some places, “*” K shaped ones in other ones, and regular triangles in the rest?
Because you need different load paths for different types of load. Understand that X shape, single diagonal, K shape, they all have differing complexities of welding. Also, more pipes means more weight. Must consider ALL of this when designing a frame.