Here is the projector loaded with a reel of film. | |
| |
there is a tricky metal flap between the projector arms that needs | |
|
|
Hinged for the loading of film through the gate and unhinged to hold the film flat on gate for projection playback | |
Put in Hinged position (shown here) for the loading of film through the gate |
Un- hinge it to hold the film flat to the gate. | |
Thread the film through the sprockets following the guide lines in red. Make sure the film sprockets are on the correct side. Only one side of the film has sprockets. | |
Here is the guide of how to load the film. Follow the red arrows in this diagram as well as the red lined arrows on the projector itself. | |
Close up of the lower winding path that is confusing |
- NOTE YOU DON'T HAVE TO DO THIS PART OF THE WIND PATH UNLESS YOU HAVE AUDIO ON THE FILM BUT IT DOESN'T HURT TO DO IT. | |
Film out to To Take up reel |
Make sure all the gates are locked |
| |
|
|
Final loaded film setup for reference. |
This is the lever that controls the film playback. Pull forward to play film forward and all the way over to get the Lamp to turn on. |