Page Comparison

To use the ATEM software, plug in an ethernet cable

to the port on the back of the unit labeled - ATEM

You MUST set the IP address on the computer to static and use the IP address of 192.168.10.5

In order to stream live, plug in an ethernet cable into the port labeled WEB PRESENTER.  

This needs to be a port that has open access to the internet.

NOTE: 

If you plug in a USB-C cable to the front port on the Web Presenter you can use the webcam feature of the Web Presenter.  This would present the PROGRAM OUT to the computer as a webcam.  You can then stream to your platform of choice, ie. FaceBook Live, YouTube, etc.  To do this you would have to log in to the account (Facebook, YouTube, etc) that you want to use.  Then  that platform will see the Web Presenter as a webcam. 

Hook up a USB cable from your laptop to the front USB port on the Web Presenter.  This is USB-C on the Web Presenter. 

Download Web Presenter Software

This will allow you to configure the Web Presenter. 

Click Once installed,  run the Blackmagic Web Presenter Set up.  It will open, search for, and locate the web presenter.  Once it is found, click the round icon show here to change settings.

Under Live Stream:

You can set where the stream will go.  

Platform = (Usually) YouTube

Server = Primary

Key = copy the stream key from the platform site and paste it where it says "Key".  

Once the stream key has been set and you are ready to stream you can click the ON AIR button. 

Or you can press the physical ON AIR button on the front of the Web Presenter.

To STOP a stream, press the OFF button.

Using the Web Presenter as a Webcam:

Plug in a USB-C cable from the front USB port to a computer and any streaming platform will recognize the PROGRAM OUT as a webcam.  Just log into the streaming platform of choice (FaceBook Live, YouTube, Twitchy, etc) and use the Web Presenter as a webcam. 

Use the Hyperdeck for PLAYBACK of media. Media to be played back should be copied to an SD card and inserted into the Playback deck.

 The media MUST be encoded as 1080i (upper field first) ProRes 29.9797 .   If media is not encoded as this it may not playback correctly or at all. 

Here is an Adobe Media Encoder preset -  Hyperdeck Pro-Res422 1080i29.97

Also, make sure that the RECORD MODE is set to ProRes.   The media must be encoded as ProRes and the Hyperdeck must be set up to record in ProRes.  If this doesn't match the playback will fail. 

The PLAYBACK Hyperdeck is routed to input 4 on the switcher.