Page Comparison

Before I could start manufacturing my mechanism, I had to choose the link material. I chose acrylic because it can be quickly cut using the laser cutter, and I thought the smooth surface would create less friction than plywood or 3D printed parts. From there, I chose to use the ¼” thickness sheet, for increased stiffness. 

For the joints themselves, I found some binding post screws at a local hardware store. Binding post screws are convenient because they have a smooth outer surface like a pin, but they also screw together for easy assembly. I’m using

screws with ½” length which fit two pieces of acrylic nicely. Sizing of the holes in the links took a few iterations with the laser cutter, but ultimately I found that a 5.1mm diameter created a secure but low-friction fit, and a 5.0mm diameter created a press fit that would limit rotation.

I chose the size of the links themselves based mostly on aesthetics. I wanted a device that would be an easy size to handle: not too small and fragile, and not too big and unwieldy. My goal was about 12” wide and I’m close to that mark.

Finally, I chose a ¼” piece of plywood as my grounding element. I thought this would provide a nice frame mechanically and visually.

The motor is bolted to the plywood using size M3 bolts.