By Susanne Kraft susanne.kraft@austin.utexas.edu
This set up is designed using our DIGI 002 ProTools LE Suites on CMB first floor
Plug in and Thread the in and | | |
| | |
Plug in the Bananna plugs into the back of the deck to the “Fully | | |
This will send the signal to the Digi 002 channel 2 “Line” input. | | |
1. Put the deck in Playback | ||
This is an example of the tape threaded properly on the Nagra | ||
Make sure the POWER is set to External not Batteries to power the unit. | ||
Double check that the Bananna plugs and plugged into the back of the deck to the "Fully Floating Line Output" Left and Right | ||
This will send the signal to the Digi 002 channel 2 "Line" input. Adjust the input gain on channel 2 to good level |
- Go to >File > New Session and name/save it to the Storage drive.
...
...
- Go to >File > New track and choose how many and what type of track you want
...
- to make
...
...
- In protools choose what channels to input by selecting the correct I/O. To
...
- show the I/O view go to >Display >Edit window shows > I/O view.
...
...
- In the I/O view you can select input and output by clicking on the Mic/Line
...
- 1 input. When this is clicked choose what source.
Ch1=MIC CH2=Nagra CH3&4=DAT etc. . .
...
...
- To choose to digitize from Nagra select Mic/Line 2 as the source.
...
...
- Enable the track for recording by pressing the R button
...
...
- The button will turn red and then on the transport click the red record button
...
- as well. Then play the Nagra tape and click the play button to start recording on the
...
- protools track.
...
...
- Adjust the gain on the channel by turning
...
- 'Gain" knobs on the 002 labeled in
...
- yellow @ the upper left corner of the 002 board. Levels should be around where
...
- the green turns to yellow on the meter. If it is hitting the red it is too hot.
...
...
12. To stop recording hit the space bar.
...