Page Comparison

1. First thing is to set  your your ISO to the sensitivity of your camera or speed of your film stock.

For example here it is set to 200.Image Removed.

Higher ISO settings are generally used in darker situations to get faster shutter speeds. For example an indoor sports event when you want to freeze the action in lower light. However the higher the ISO you choose the noisier shots you will get.

Image Added

2. Next if you are  outside you need to put in the HIGH Slide

Located in the back of the meter.

3. Note that there are two readings one for the high pointer and one for the low pointer

4. Make sure the knob is in the  locked position by pressing it down and turning to the left so the button pops out so it is not  in constant mode.
   This means you must press the button for the light meter to get a  reading

5. Point the  Meter White Sphere towards the camera very close/near the subject where you have the camera pointed and press button to get the light reading

6. The  reading here shows @ 80  foot candles. It also shows where to set the F-­Stop (@4)

7. Set the Dial to 80 and this will show you the F-­Stop to set the camera.

8. When the  dial is set  to 80 (the reading we got from our light meter)
 The meter shows us the F-­Stop we need to set our camera.
  
This sets the amount of light needed to properly expose film based on the film speed that was
 entered in step 1.