...
Turn on HDV Deck | ||
Click on Menu | ||
Make sure HDV/DV is set to DV | ||
Click on Video Out | ||
Set to HDMI / CMPT to 480i | ||
Audio Mixer make sure the Tape to mix button should be pushed to get the audio from the DVCAM deck. | ||
Audio Mixer Look for HDV 3 Turn up input level to about 0 db should be a good level | ||
Make sure the Thunderbolt cable is connected to the computer back of the (IMac) There will be an adapter that looks like this connected to a cable connect the cable and adapter to the IMac that will be the connection to the Terranex | ||
Put the tape in the deck | ||
Click on PLAY make sure there is some image on the tape and play for a at least 20 seconds Tip- It's good to play the tape while the Terranex is turning on so the signals sync | ||
Turn on the Teranex and wait for it to power on it'll be about a minute | ||
System Prefs >Blackmagic Desktop Video | Click on the Setup Icon | |
System Prefs >Blackmagic Desktop Video Click On Video Input | ||
Click on the Audio Tab and change the Audio to XLRRCA Click on Save | ||
Open Blackmagic Media Express | ||
Go to >Media Express> | ||
Set the Video Format to | ||
Click on the Log and Capture Tab in Media Express | ||
You should see audio levels Then click on the Capture Button to start capturing. Capture Button will turn RED | ||
Click Capture to stop capturing | ||
Turn off the Teranex when finished | ||
Turn off the VTR's when finished |
...