Turn on The deck you want to use in the dub rack | |
Go to the |
video patch panel |
. Patch the deck you want to use into the |
Teranex In our example we are capturing from |
VHS002 so we have the VHS deck patched into |
the Teranex Composite Y In | |
If you wanted to capture from Hi-8 or |
3/4 inch just move the |
patch from the VHS to the Hi-8 or |
3/4 Out. |
Patch |
Patch out of the TBC and into the Teranex Y/NTSC/PAL IN
You are also going to have to move the audio XLR Left and Right to the correct output for the
deck you want to use
This will be patched into the small audio board on the desk and this will send audio into
the Teranex
Make sure the Thunderbolt cable is connected to the computer (IMac) and the Teranex
Click on PLAY make sure there is some image on the tape and play for a at least 20 seconds
to the Teranex Composite Y In | |
Audio Input Set the Master slider to about 0 Find the 3/4, VHS or Hi8 on the Audio mixer Raise the level up on the slider to abou 1/4 to 1/2 way up (-10 to 0 range) | |
Put the tape in the deck |
Turn on the Teranex - |
System Prefs >Blackmagic Design Desktop Video
It'll take a bit to turn on, | |
Go to >Apple>System Settings > |
|
Scroll all the way down and Choose Blackmagic Design Desktop Video | |
Click on Teranex settings icon shown here | |
Video Input - Change Input to Composite Video |
Audio Input - RCA Audio | |
Open Blackmagic Media Express | |
Go to >Media Express> |
Settings |
Set the Video Format to |
Close that menu | |
Put the tape in the deck and hit Play | |
Click on the Log and Capture Tab in Media Express |
Set Input or "IN"
Video – Analog or ANLG
Audio – Analog or ANLG
Format – 486
Frame – I
Rate 59.94
Aspect Leterbox
ADJ – can adjust levels and some other things
NEXT - SELECT ANLG ON THE VIDEO TAB
Analog > XLR > Analog Input
Video – SDI
Audio – EMBED - Analog
Format – 1080
Frame – P
Rate 23.98
Aspect Leterbox
ADJ – can adjust levels and some other things
Wait about 5 or so seconds | |
You should see image and audio levels Then click on the "Capture" Button to start capturing. Capture Button will turn RED | |
Capture Button will turn RED |
Click Capture to stop capturing |
Turn off the Teranex when finished | |
TURN OFF THE VTR'S WHEN FINISHED |