...
- Install the necessary software
- Plug in the CANdapter to your Computer
- Turn on the Power Supply to 12V
- Verify the voltage via the multimeter
- Turn off Power Supply
- According to the Motor Controller Datasheet:
- Plug in the CAN High and CAN Low wires from the CANdapter to the CAN High and CAN Low wire ports into one of the motor controller CAN ports
- Plug in the Power and Ground wires from the Power Supply to the motor controller's +12V and GROUND wire ports
- Plug in the CAN High and CAN Low wires from the CANdapter to the CAN High and CAN Low wire ports into one of the motor controller CAN ports
- Turn on the Power Supply to 12V. There should be a green LED under the motor controller panel on
...