ProTools - Focusrite RED4Pre Surround Sound setup CMB 4.112A and CMB 4.112B

	Open Focusrite Control if you haven't already Note if installing on a new computer you might have to play with the Mac Security settings making sure that you allow access Trick is to log in as admin and re-install making sure that you allow security access No Hardware Connected For No Hardware Connected on macOS– click here. document is also saved on software in the Focusrite folder
Once installed and running Make sure that the FocusRite is synced to Internal If you don't have it synced correctly no sound will come out. Click on Device Settings Red 4Pre Clock Source make sure it is internal
Click on >File Load Snapshot We have a snapshot for both A and B suites because they are different
Go to >Tempstorage> Templates>Focusrite surround sound setup.ff Click Open Note in case it's lost here are the settings for outputs 3-8 for Suite A
Note in case it's lost here are the settings for outputs 3-8 for Suite B
Open audio midi setup Choose >Focusrite Thunderbolt
Configure Speakers
Choose Configuration 5.1 Surround >Focusrite Thunderbolt and 5.1 surround config Each speaker output should send a signal to this cable
Choose Apply and >Done

















Next open protools ultimate to get 8 channels output Set playback engine to
Set to Focusrite Thunderbolt
Then Import the surround sound template for the input and the output
Choose Import Settings
Choose >tempstorage>Templates> UT RTF Default .pio
Choose NO here
Click OK

No Hardware Connected