| Barry Green and Panasonic have created this ebook download it here |
| ||||||
|---|---|---|---|---|---|---|---|
Setup the Tripod first
Spread the legs of the tripod to the width you think will be wide enough to support the tripod |  | ||||||
Adjust the length of the legs so they are even and the desired height you want the camera |  | ||||||
The knob underneath the tripod head will allow adjustment of the head so you can level it using the yellow Bubble on the tripod head |  | ||||||
| Bubble on the tripod head used to level the tripod |  | ||||||
Turning the knob on the side of the tripod will allow you to adjust the handle on the tripod. |  | ||||||
| Screw in the tripod plate in the "third" smaller hold and tighten |  | ||||||
Pull Latch shown here to unlock the plate and push it in to lock the plate on to the tripod
|  | ||||||
using this wiki for the Libec Tripod - How to Setup and Use
| |||||||
Open the back door and put the batter inside |  | ||||||
Or plug in the external power supply to the "DC Input" on the side of the camera. |  | ||||||
| Turn on the camera |  | ||||||
| Pull the viewfinder out of the slot on the top of the camera |  | ||||||
| Flip it up to see the menus and camera display |  | ||||||
| The camera uses SanDisk Extreme 64 GB 90 MB/S SDHC Cards |  | ||||||
| Make sure two cards are loaded into the card slots |  |
Page Comparison
General
Content
Integrations