Versions Compared

Version Old Version 1 New Version Current
Changes made by

Jacob Yan

Jacob Yan

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
  1. Login to TACC
  2. Navigate to the directory specified in your ANSYS log paths
    1. Peferences → Settings Settings to find the location
    3. Navigation tools
      1. ls → shows you what's in the current directory
      2. cd → FILEPATH change directory to the listed filepath
        1. cd .. → go back one directory
        2. cd ~ → 
    4. check if the file exists → 
      1. compress file image.pngImage Removed
    5. from new terminal, grab compressed file
    6. image.pngImage Removedwhere you are
      1. when in the directory for your ansys, type "ls -la" which will list all folders/files in your current directory 
    7. compress file - Run the command below in your appropriate folder
      1. The screenshot is zipping my entire ansys folder, if you just want the log files, fill out the highlighted command
      2. tar -czvf name-of-archive.tar.gz /path/to/directory-or-file-name
      3. Image Added
    8. Grab the file off of TACC
      1. Navigate to where you want the command to dump the zipped file, then run the 2nd line in the screenshot below
      2. from terminal in your pc, grab the compressed file with the command in the screenshot(last line)
        1. Replace:
          1. jacobyan → your username
          2. 099768/jacobyan → filepath to your ansys folder/log file location
        2. Image Added