Versions Compared

Old Version 2

changes.mady.by.user Courtney Morshed

Saved on

compared with

New Version Current

changes.mady.by.user Cole Marchant

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: updated naming convention


...

Excerpt

Problem

This guide is intended to be used to start a job  that was inadvertently terminated.
A Job may stop or fault for a variety of reasons. The '-- Unexpected Output Fault ! --' error is caused by a miss-step in communications from the workstation to the Shoptbot controls.

...

Troubleshooting

...

Solution

If you receive a '-- Unexpected Output Fault ! --' error, make sure to note down the line number in the 'Current Line' box.

...

...

  1. Clicking 'Close & Exit' will exit out of all shopbot applications and is not what we want.
  2. Clicking 'Quit' will keep out calibration settings and allow us to immediately run a file without re calibrating.
  1. Enter command 'FG'

...

  1. This command allows you to choose which line in the file to start your job at. we will want to resume our job on the same line number.

...

  1. to resume a job at a specified line in the code
    Image Added
    1. Click 'Setup a Re-start of this file'

...

    2. Enter your desired starting point in the 'Line Number' box
    3. Click 'GO'

...

    1. and allow the ShopBot to move to the

...

    1. desired start position
  2. Click 'Run from Here'

...


  1. Image Added
  2. The ShopBot will notify you to turn on the spindle by pressing the green 'start' button

...

  1. (right side of ShopBot pendent)
  2. Verify VISUALLY that the bit is now rotating in the spindle

...

  1. Click 'Yes/OK'

...

  1. while keeping your hand near the red EMERGENCY STOP button while the operation starts




Page Properties