Below is an image of the error message you will receive.
This error is caused by a miss-step in communications from the workstation to the Shoptbot controls. The error is easy to fix by running your file from the current line; which will resume your job.
Troubleshooting
- Note down the number in the 'Current Line' box.
- Click 'Quit' not 'Close & Exit'
- Clicking 'Close & Exit' will exit out of all shopbot applications and is not what we want.
- Clicking 'Quit' will keep out calibration settings and allow us to immediately run a file without re calibrating.
- Enter command 'FG'.
- This command allows you to choose which line in the file to start your job at. we will want to resume our job on the same line number.
- Start by verifying the 'Line Number' starts 10-steps prior to where the error occurred.
- If the operation failed at line 133753, round it down by at least 10 lines, this will send your operation back by 10-steps. the new number will be 133740 in this case.
- Verify 'setup a re-start of this file' is selected
- Click 'GO'
- The CNC will move to the operation line
- Press ' Run from Here' to start the operation.
- CNC will ask you to press the green 'start' button to turn on the spindle
- Then Press 'OK'
