Check that the WHITE Thunderbolt cable is plugged into the IMac | ||
Make sure the other end of the WHITE - Thunderbolt cable is plugged into the Blackmagic Design Intensity Pro as shown here. | ||
Log into the computer | ||
| ||
| ||
Click on Settings Button | ||
Click on Video> | ||
Click on Audio Tab (if there is one) > Click on RCA Close the Desktope Video click the red button in the corner | ||
Back to System Preferences Select Sound | ||
Select Output Tab > Blackmagic AudioOption | ||
If you have video you would like to use in your protools session turn on the TV MAKE SURE THAT THE SOURCE IS SET TO COMPONENT - | ||
PRESS THE SOURCE BUTTON UNDERNEATH THE "9" KEY TO SET INPUTS ON THE MONITOR - Don't change this should be set correctly but just in case it should be set to component input. | ||
If you are in suite CMB 1.108B then you have a newer Monitor and have this remote Power and Input buttons will be what you need. Input should be on HDMI | ||
Select the application that you want to run AVID or Davinci Resolve or Premiere | ||
Choose "Premiere Pro CC > Preferences > Playback..." | ||
Choose Blackmagic Playback
Click OK | ||
Choose "Premiere Pro CC > Preferences > Audio Hardware..." | ||
Make sure you Preferences look like this | ||
If you get this error click Yes | ||
Click OK | ||
Don't forget to pan channel 1 LEFT & channel 2 RIGHT and don't use any other tracks | ||
USE ONLY TRACK MIXER not CLIP MIXER | ||
Some of the Suites on the 1st floor have a Mixer. The mixer settings are shown here.
Channel 1 and 2 are AVID playback are ProTools playback
Also turn up the Master audio on the Board labeled Volume | ||
Some suites have the Mackie Big Knob ProTools and AVID Inputs are labeled and use Monitor Select B make sure Mute is not pressed |
Anchor | ||||
---|---|---|---|---|
|