Please follow the steps below to install the printers using the Mechanical Engineering print server.
**You must be on the UT network (wired or wireless) or connected to the UT VPN if off campus to add this printer and print to it.**
The GLT printers are locked down using individually assigned ID and PIN. Do not share your ID and PIN with anyone else. Print usage is tracked per individual.
1. Open Windows File Explorer by clicking on the folder icon on the taskbar or right click the Windows Start icon and select "File Explorer".
2. In the address bar near the top of the File Explorer window, type in \\me-print1.austin.utexas.edu\ and press Enter.
3. Locate the printers ME-GLT-Floor-2-Cano and/or ME-GLT-Floor-3-Canon near the bottom of the list of printers that appear in the folder.
4. Double-click on the desired GLT printer (only one at a time). After a few moments (up to 30 seconds or so where your computer may seem like nothing is happening), you should get a dialog box similar to the one below. Do the same for the second printer if you want to install it. You can close the pint queue window that opens.
5. Once the installation completes, verify the printers were installed by going to Start and typing "Printers" and then selecting "Printers & scanners"
6. In the Printers & Scanners window you should see the printers installed as ME-GLT-Floor-2-Canon on me-print1.austin.utexas.edu and ME-GLT-Floor-3-Canon on me-print1.austin.utexas.edu.
