About
This Subscription grants access to our Digital Fabrication equipment:
- 3D Printing
- CNC Knife
- CNC Router
- Laser Cutters
- Robots
All students enrolled in a design studio* are charged for this Subscription unless that student submits an opt-out survey before the twelfth class day. This survey is sent to the students after studio lottery. Students not enrolled in a design studio aren't charged for this Subscription automatically and don't need to submit an opt-out survey. Any student who wishes to subscribe can do so at any point in the semester.
Subscription Cost
Fall | Spring | Summer |
---|---|---|
$50 | $50 | $20 |
Notes
- The subscription will be billed to your What-I-Owe account
- There is no pro-ration on the cost of the subscription if you decide to join later in the semester
- The use of the equipment is not available at an hourly rate
- Group work is billed per user of the equipment; no 'sharing' a subscription and this applies to research projects
- Fabrication work done in service of research projects will be billed to the appropriate UT accounts before users will be allowed to access equipment
- Foam bits for the CNC Router & 10mm round point bits for the CNC Knife are included in the fabrication subscription and are available for checkout from the Tech Desk
- Bits broken by the user due to misuse will be charged the full amount of the bit to their WIO
Design Studios*
These are the only studios that are automatically enrolled in the subscription. If you aren't enrolled in one of these studios, you do not need to complete a survey.
Fall
- Advanced
- Design III
- Design III Interiors (beginning Fall 2024)
- Design V
- Design V Interiors (beginning Fall 2024)
- ID Core Studio I (beginning Fall 2024)
- ID Core Studio III (beginning Fall 2024)
- Integrative
- Vertical
Spring
- Advanced
- Comprehensive
- Design II
- Design II Interiors
- Design IV
- Design IV Interiors
- Design VI Interiors
- Horizontal
- ID Core Studio II
- Technical Studio