Ross Crossover Switcher – How to set the “Still Store Media” key type

To configure Media-Store mode: Press MENU.
Press the SYSTEM Wipe Pattern button.
Press NEXT until Media is displayed. Use the Media knob to select the Media-Store mode. You can choose from the following:
Turn knob so that the first setting is set to Dual not Tall Press the Media knob to save your selection. Press the Confrm knob to commit the change. If it is already set to Dual then don't do anything else
Images must be 24-bit or 32-bit (24-bit image plus 8-bit embedded alpha channel) Targa files. Save Graphics as 1920 x 1080 Animations must be Targa sequences, a collection of individual image files (one file per animation frame).	See DAVID's wiki doc on how to save lower thirds How to create lower thirds See how to create Graphics for use in the Still Store
Insert USB Stick into the crossover switcher Access the crossover control unit by removing the protective cover on the front of the unit. The black handles release the cover. On the right-hand side of the unit, around the corner from the power switch is a USB port.
On the switcher select a source to assign the key to. In our case in 4A control we have all the first 10 inputs assigned so we went to the next 10 assignable inputs by holding down the "shift" key you access the additional 10 inputs. EX: her press "Shift Input 8 or Shift Foshcam" for input 18
Press the button to navigate the menus and select USB and then turn the knob to locate the correct .tga file to use as a key. Press or Push to load it
Choose the key to use press Autoselect>Key 1, 2 or 3 and then select "Shift Input 8" or whatever source the media store is using as a source

Press source on the aux/key bus
You can change the following settings as well to get a good key May have to press the key input again on the key bus