Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Adding catalog numbers to the surface of a specimen is a task that requires practiced, legible writing and a steady hand. It is best to warm up on scraps of paper before adding anything to the specimen. Read carefully the procedure for specimen numbering, and feel free to ask the collection manager for the practice shell to warm up on. 

The first step is the same for every conservation task- lay out your workspace in a clean and well ventilated area.

 

Gather the specimens needing numbers and line them up, in order, on a cafeteria tray.

Practice writing catalog numbers on piece of paper to determine how much space you'll need to write clearly the catalog abbreviation and specimen number. Leave off leading 0's, and suffixes of ".000".

Locate a spot to apply the base coat. Look for a flat area of matrix, preferable in an unobtrusive spot, equal to or larger than the practice space. Specimens free of matrix should be numbered on a spot that does not obscure any important features.

Paint a strip of B-72, let dry. If doing multiple specimens this step can be done on each specimen before proceeding to the next step.

Put a couple of drops of Titanium White into the paint tray. Using a soft bristle brush, pick up a small amount of paint and apply smoothly over the B-72. Let dry.

With a Micron pen, or other archival ink pen, write the specimen number. Make sure you write clearly and legibly. If you make a mistake, don't try and 'fix' it by writing the correct number over the mistake. Wipe the ink off, lay down another coat of white and start over. Let dry

Ink must be fully dry before starting this next step.

Load the applicator brush heavily with B-67. Put the drip on the numbering surface and, with as little brush contacting the ink as possible, cover the specimen number. You only have one pass to cover the numbering, so it is worthwhile to practice first.

 

 

 

Materials needed:

  • Pen

 Micron or Pigma pens should be used for writing catalog numbers on specimens. Other brands of pens and ink may be allowed, check with the collection manager before using.

  • B-72 (Base coat)

Acryloid B-72 is laid down as a base coat to prevent ink from seeping into the specimen. DO NOT USE CLEAR NAIL POLISH.

  • B-67 (Cover coat)

Clear Acryloid B-67 lacquer, in naphtha 25% solution is currently being used at a cover coat. Acryloid B-72 in acetone 25% solution may also be used.

If numbering dark specimens, you will also need the following:

  • Titanium White acrylic paint

Artists grade Titanium White acrylic paint is used on dark specimens to create an area where the number, written in black ink, can be seen. Do not use Zinc White acrylic paint, or hobby grade paint. DO NOT EVER USE WHITE OUT CORRECTIVE FLUID.

  • Paint brush and brush cup

Use a container that is not used for drinking as a     brush cup. A soft bristle brush will create a smooth application of the Titanium White coat. Do not let the paint dry on the brush, wash immediately and thoroughly when you are done with the white coat.

  • Paint tray, watch glass or petri dish

 

  • No labels