Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
Version 1
Next »
Build Iteration 1: Initial linkage mechanism testing
Description: Parts cut out of 1/4" wood via laser cutter were used to test linkage mechanism movement. Links were attached via M4 screws and nuts at joint locations.
Build Iteration 2: Linkage mechanism with actuator
Description: Once again most parts were cut from 1/4" wood and some 1/4" acrylic via laser cutter. The difference was made to show "hidden" linkages that will be present in the final design. This design, unlike the first iteration, has a bigger back plate that allows a motor as well as electronics to be attached for proper actuation of the input link of the linkage mechanism. This is also the first design in which we have implemented a uniquely shaped link that resembles the leg of a dog, iterations of this to be done in the future.
Results: This build iteration matches our desired linkage movement that we accounted for, however after obtaining feedback we will have to modify the linkage system quite a lot to change the motion of the leg to more resembles the motion a dog makes while walking. Another big issue we found is that we would like to move away from screws in joints and move towards shafts and collars. This will solve issues that are present with screw joints such as the unscrewing of the nuts, and reduce friction in the joint itself.
Bill of Materials: