Seventh Workday Plan - 11/9/2024

General

Suspension

Steering

Unsprung

Quick review of one person from each subsystem on what they are doing/did

Gerard and Philip lecture on CAD best practices and naming convention

review of clickup tasks - we can break them down

Collab meetings should happen on workday rather than justtt indiv work:

• Carter will meet w arav and lock down the kinematics software contacts - ADAMS is the goal

• Manas x Jonathan rear trailing arm CAD - discussion of hardpoints

  • update sami and i on any decisions

• la’akea will go to composites to catch up and also see the new inserts -

• Oliver doesnt really have a lot of overlap with other subsystems - if possible i think itd be a good idea to confirm and bearing calc research and selection ideas with unsprung (@Sumana Subramanian )

• Joshua do bump steer and rest of workday

Rough draft of CAD should be done by end of workday

• Unsprung meeting tmr

• End of workday diameter

• Sohan does brakes CAD

• Sami does hub CAD

• Sumi does upright CAD

• Jonathan x Manas does rear trailing arm CAD

  • Where the mounting points are and the CAD should help visualize it

Rough draft of CAD should be done by end of workday.

End of workday meeting

• Everyone goes through what they did first members then subleads

• Subleads tell their members what they will be doing throughout the week (technical things related to their task)

• General thing they will be doing throughout the week (CAD)