| Name | What They Did |
|---|
| Philip |
|
| Suspension |
|
| Andrew | - got feedback from jacob/nathan on wishbone manufacturing plan
- trained dyn ppl on manual mill
|
| Kadhir |
|
| Kayla |
|
| Unsprung |
|
| Gerard | - continued to prepare to manufacture axles
- addressed all of the remaining problems with the manufacturing plan
- finalized dimensions and tolerances
- helped measure inner diameter of bearings and hubs
- watched single point thread cutting videos
- got feedback from Jacob and Nathan on plan
|
| Steven |
|
| Sami | - Face the wishbones down to .5" → Kadhir later took over.
- Discussed the manufacturing plan for uprights with Nathan, Jacob, and Harshit.
- Learned how to use the Manual mill.
|
| Harshit | - Read Mathew's design guide about unsprung
- Got feedback from Jacob/Nathan on Uprights manufacturing plan
|
| Steering |
|
| Luis |
|
| Anh |
|
| Katy | N/A |
| Evan |
|
| Frame |
|
| Kaitlyn |
|
| Josh | - Learned how to use manual mill and roughed aluminum steering stopper plate
|
| Noah | - Trained on the manual mill by Andrew where I began the fabrication of the steering stop plate
|
Welcome to the University Wiki Service! Please use your IID (yourEID@eid.utexas.edu) when prompted for your email address during login or click here to enter your EID. If you are experiencing any issues loading content on pages, please try these steps to clear your browser cache. If you require further assistance, please email wikihelp@utexas.edu.