Ross Crossover Switcher - How to Reset the Switcher

Do not do this unless you have locked up the switcher.

Do these steps:

Ross reset

Menu>Reset>Next>Factory Reset>Push the button>Confirm>

If that does not work do this next

Go into the production control room behind the CMB Proctor desk Find the Ross Crossover Switcher Press in towards the middle of the rack the two black tabs to open the fron
Turn off the power button here. Wait about 3 minutes and turn on Then it'll take about 5 or more minutes to boot up
Then you will have to do the Studio 4A – Ross Switcher – Audio N – Pass Setup	Ross Crossover Switcher - N Pass setup
You then need to set the switcher to External Sync	Ross Crossover Switcher - How to set to External Sync
Need to check the Crosspoint Routing and Shift Crosspoint Routing	Ross Crossover Switcher - How to Check and Set the Crosspoints and Set Correctly
Then you must set the Alpha channel for the CG up again.	Ross - Crossover Switcher - How to fix the Character Generator or Ross XPressions Alpha Chanel
You must also set the Chroma Key channel again.	Ross - Crossover Switcher - Chroma Key settings
Set the Frame Sync for the Remote Camera	Ross Crossover Switcher - How to Fix a Sync Line in Remote Camera Input or Frame Sync the Input
How to set the key and dissolve transitions	Ross - Crossover Switcher - How to set the Key Transition Durations Cuts