ProTools - Video and Audio Monitoring Setup in CMB Grad Suite Edit Labs
Audio will play through the speakers out of ProTools but must follow these steps
Use the remote to turn on the Monitor Power for the Wall TV |  |
On the PreSonus Audio Monitor Controller
Select the Aux Input and Turn up the Volume knob
Speaker Select Speaker A Select Main Source ST1 |
|
This Aux Input will also boost audio Make sure that the Aux button is not pushed to SPDIF that'll mute the audio | |
Open ProTools |
|
Click OK Here |
|
Click Allow Here |
|
Click Allow Here |
|
Click Next Here |
|
Choose >Blackmagic Option for the Playback Engine in all suites except CMB 4.112A and B and the CMB 2 floor Foley suite |
|
Choose No here |
|
Next OMy pen the ProTools session if you have one created already or make a new session. | |
Navigate to the session and open it or create a new session | |
To create a new Protools session Type - Session Name - (session name) File Type - .WAV Bit Depth: - 24 bit Sample Rate: - 48kHz I/O last used
Location - set to your hard drive NOT THE DESKTOP!!!! |
|
Next Import the video into the project |
|
Navigate to the video file that you want to view in the ProTools session | |
Choose to import at Session Start
Also choose to Import audio from file |
|
Choose to enable the Video Engine | |
If you would like to use the audio off the video file choose to save it to the default Audio Drive folder | |
Next go to >View>Edit Window Views>I/O |
|
Choose the video resolution of the file from the choices. Probably best to choose a 1920x1080 that is the most common |
|
Make sure all the audio outputs are routed to the Built In Line Output 1-2 Stereo Mac Pros or Out 1-2 Stereo Built In Output 1-2 IMacs Then you should see image on the TV and hear audio the speakers
| |